ABOUT THIS MANUAL
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
28/266
1.5.2. Mechanical installation
The personnel must be qualified to prepare the installation site according to the
site and equipment requirements and to perform the installation accordingly.
1.5.3. Electrical installation
Personnel must have a sound knowledge of the relevant electrical codes and
specifications covering low and medium voltage equipment, be experienced with
electrical wiring principles and know the electrical symbols typically used in wiring
diagrams.
1.5.4. Operation
The personnel include all persons who operate the drive from the local operator
panel of the drive. The personnel must know the functions of the operator panel,
be adequately trained for the drive, and know the driven process. Special
knowledge of frequency converter technology is not required.
1.5.5. Maintenance
The personnel include all persons who
– Are qualified to carry out preventive and corrective maintenance on drive as
described in this manual
– Are thoroughly familiar with the drive
– Have a sound knowledge of the relevant electrical codes and specifications
covering low and medium voltage equipment
– Are able to assess the hazards associated with the energy sources of the drive
and act correspondingly
– Know the safe shutdown and grounding procedures for the drive system
1.6. User’s responsibilities
It is the responsibility of those in charge of the drive to ensure that each person
involved in the installation, operation or maintenance of the drive has received the
appropriate training and has thoroughly read and clearly understood the
instructions in this manual and the relevant safety instructions.
1.7. Intended use of equipment
Those in charge of the drive must ensure that the drive is only used as specified in
the contractual documents, operated under the conditions stipulated in the
technical specifications and on the rating plate of the drive, and serviced in the
intervals specified by ABB.
Use of the drive outside the scope of the specifications is not permitted.
Intended equipment use also implies that only spare parts recommended and
approved by ABB must be used.
Unauthorized modifications and constructional changes of the drive are not
permitted.
To Next Page
Loading...
Need help?
General
