ELECTRICAL INSTALLATION
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
155/266
6.9. Heating cable
This section applies to drives that are delivered in multiple transport units and are
equipped with a heating cable.
Procedure
1. Connect the power supply of the heating cable.
NOTE – For more information on power supply connections, see the converter
hardware diagram in “Appendix D - Wiring diagrams”.
2. Connect the heating cables of two adjoining transport units with each other.
3. Fasten the connectors with cable ties.
Figure 6-44 Heating cable connection
1) Heating cable plug 2) Cable tie
1 1
2 2
To Next Page
Loading...
Need help?
General
