ABOUT THIS MANUAL
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
19/266
1. About this manual
1.1. Equipment covered by this manual
This manual covers standard drive and provides generic information on the drive.
The manual does not claim to cover all variations and details of the drive, nor to
consider all eventualities that may arise during installation, commissioning,
operation and maintenance of the drive.
If the drive is adapted to specific customer needs or applications, and handling,
installation, and operation of the drive are affected by these modifications,
information on these modifications is provided in the appropriate documentation
(such as layout drawings, wiring diagrams, project-specific data, engineering
notes).
If information is required beyond the instructions in this manual, refer the matter
to ABB.
1.2. Structure of the user documentation
The documentation for a standard drive consists of this document and the
following project-specific appendices.
NOTE – These appendices are NOT included in this document.
– Appendix A - Additional manuals provides manuals about additional equipment
delivered with the drive (such as project-specific options such as pulse
encoder or fieldbus interfaces), or information on modifications of the
standard drive.
– Appendix B - Technical data contains the technical data sheets of the drive.
– Appendix C - Mechanical drawings provides the outline drawings of the drive. The
drawings are generated according to the customer-specific project.
– Appendix D - Wiring diagrams contains the circuit diagrams with information on
device identification, cross-reference and device identification conventions.
The diagrams are generated according to the customer-specific project.
NOTE – “Setting of protective devices” is generated according to the
customer-specific project.
– Appendix E - Parts list is produced for each project and contains all information
to identify a component.
– Appendix F - Test reports and certificates provides the test reports of the drive.
Quality certificates, and codes and standards the drive complies with are
added if necessary for the project.
– Appendix G - Signal and parameter table includes descriptions of actual signals,
control and status words, and control parameters and their default settings.
To Next Page
Loading...
Need help?
General
