Chapter 1: Introduction
16 2X-A Series Installation Manual
The following system status events are also added to the event log (but are not
included in the control panel current events report).
Table 10: Other system status events added to the event log
Description
An output group is activated or deactivated or a
programmable system command is executed (via the
Configuration Utility)
A system condition is deactivated
The control panel is
reset, the panel is silenced, a new date
and time is set, the system is initiated, etc.
Power supply faults eliminated
A previously logged power supply fault is resolved
A rule is activated [1]
The date and time
information for activation and termination
of user sessions
[1] A rule consists of one or more states (combined by Boolean operators) that are configured to
trigger specific system actions after a specific confirmation time. Rules are created using the
Configuration Utility.
To Next Page
Loading...
Need help?
General
