133R5906112 /15 UDX
Image 10–21 Example of the available networks list.
10. Press Connect to connect to the selected network.
11. If required by the chosen wireless network, fill in the username and password and confirm.
When connected to this network, it is indicated in the upper right corner of the menu with the term
“connected”.
10.3.4 LAN over HDBaseT
TM
IP address set up
LAN over HDBaseT is only supported on HDBaseT
TM
Input 1 on the Pulse Quad Combo Input
board Mk II.
About LAN over HDBaseT
TM
When a LAN cable is mounted in HDBaseT
TM
input 1, the HDBaseT
TM
menu will appear in the Settings menu.
Using the menu, you can assign a custom IP address, or leave the automatic IP address setup.
Keep into account that the HDBaseT
TM
network will be unavailable if the projector is in Standby
mode or ECO mode (whichever is applicable to your projector). If you want to use this connector as
your main network connection, it is thus advised to disable the standby or ECO mode. For more
info, see power settings.
How to automatically set up the IP address
1. In the main menu, select Settings → Communication → HDBaseT
TM
.
Image 10–22 Communication menu, HDBaseT
TM
The HDBaseT
TM
menu is displayed.
GUI – System Settings
To Next Page
Loading...
Need help?
General
