EasyManua.ls Logo

Belarus 3522.5 - Connector Elements of the Electrical Equipment; Socket to Connect Coupled Agricultural Equipment; Installation of Electrical Sockets

Belarus 3522.5
340 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3522.5-0000010 РЭ
85
2.22 Connector elements of the electrical equipment
2.22.1 Socket to connect coupled agricultural equipment
A standard seven-pin socket with an additional receiver to connect a portable lamp (figure
2.22.1) is intended to connect current consumers of a trailer or trailed agricultural implement. It is
mounted on the RLL bracket. A male plug of wire harness from a trailer or coupled agricultural im-
plements is connected to the socket.
1 – left turn indicator; 2 – horn; 3 – ground; 4 – right turn indicator; 5 – right clear-
ance lamp; 6 – brake light; 7 – left clearance lamp; 8 – receiver to connect a portable lamp
or other electrical elements with useful current up to 8 A.
Figure 1 – Assignment of socket terminals to connect trailed agricultural implement
2.22.2 Installation of electrical sockets
Apart from the socket to connect a trailed agricultural equipment “BELARUS-
3522.5” tractors are equipped with additional electrical sockets. These sockets installation
as well as cigar lighter installation is presented in figure 2.22.2.
Power to the front socket 2 (figure 2.22.2), to the rear socket 5 and to the cigar lighter
4 is supplied after the accumulator battery is switched on. Power to the rear socket 6 is
supplied after the engine is started.
Max. current loads on the sockets and the cigar lighter are as follows:
o front socket – 25 A;
o rear sockets – 25 A;
o cigar lighter – 10 A.
It is allowed to use the cigar lighter socket as a receiver to connect electrical con-
sumers with current load not exceeding 10 A.
The fuse for the front socket 2 is located on the fuse block, which is mounted in the
engine compartment (see subsection 2.17 “Cutout fuses”), the fuses for the rear sockets 5,
6 and for the cigar lighter are located in the protection and switching unit PASU (see sub-
section 2.19 “Protection and switching unit”).
Socket mating jacks (electrical plugs) are enclosed to tractor spare parts, tools and
accessories.
ATTENTION: CONNECTING CONSUMERS, STRICLY OBSERVE THE POLAR-
ITY, SPECIFIED ON ELECTRICAL PLUGS!
https://tractormanualz.com/

Table of Contents

Related product manuals