Brother PJ-722 User Manual

Setting Up the Printer
12
1
Removing the Rechargeable Li-ion Battery 1
a Move the battery latches to the unlock position, and then remove the battery.
1 Battery latches
b Insert the battery cavity mounting block into the battery cavity until it locks into place.
c Move battery latch 1 to the lock position.
Charging the Rechargeable Li-ion Battery 1
Note
• Charge the battery immediately after purchase using the following procedure.
• Up to three hours are needed to fully charge the rechargeable Li-ion battery. When fully charged, the
battery will print about 600 pages.
a Turn the printer off and install the battery.
b Use the AC adapter and AC power cord to connect the printer to an AC power outlet (see Connecting to
an AC Power Outlet (Optional) on page 14), or use the car adapter to connect the printer to a DC power
outlet (see Connecting to a DC Power Outlet (Optional) on page 15).
1 POWER indicator
2 STATUS indicator
c When the battery is fully charged, the STATUS indicator turns off. Disconnect the AC adapter or car
adapter from the DC connector.
1
1
2

Brother PJ-722 Specifications

General

Print Technology	Direct Thermal
Print Speed	Up to 8 ppm
Interface	USB
Power Source	AC adapter
Dimensions	255 mm x 55 mm x 30 mm
Weight	480 g
Paper Size	A4, Letter
Media Type	Roll paper, Fanfold paper