● When sending an original with many pages, divide the original and send it.
● Change the set r
esolution to a lower resolution when scanning the original.
[Home] screen on the control panel [Fax] [Resolution] select the resolution.
Cannot Receive a Fax
Ask the sender to divide the original or lo
wer the resolution and send the fax again.
#005
There was no response from the other party's device within the time limit.
Did You Specify an Overseas Destination?
You may not have been able to connect correctly to the destination. After entering the international access
number or country code, enter the wait time (pause) or lower the communication start speed before sending
the fax. Cannot Send a Fax to an International Destination(P. 612)
Is the Other Party
's Device Ready to Receive a Fax?
The power of the other party's device may not be turned on, or the RX Mode may not be congured correctly.
Have the other party check these.
#012
The r
eceiving device is out of paper (recording paper).
Have the other party add more paper.
#018
Ther
e was no response from the other party's device due to it being busy or another reason.
Did You Specify an Overseas Destination?
You may not have been able to connect correctly to the destination. After entering the international access
number or country code, enter the wait time (pause) or lower the communication start speed before sending
the fax.
Cannot Send a Fax to an International Destination(P. 612)
Is the Other Party
's Device Ready to Receive a Fax?
The power of the other party's device may not be turned on, or the RX Mode may not be congured correctly.
Have the other party check these.
#022
Sending of fax
es from a computer is restricted. Alternatively, the destination specied as the forwarding destination
may have been deleted from the Address Book.
To Cancel Restriction of Sending Faxes from a Computer, Change the [Fax TX Settings] Setting.
Log in to Remote UI in System Manager Mode [Settings/Registration] [TX Settings] [Fax TX Settings]
[Edit] select the [Allow Fax Driver TX] checkbox [OK]
On the control panel, select [Menu] in the [Home] screen, and then select [Function Settings] to change the
setting. [Allow Fax Driver TX](P. 489)
Register the Forwar
ding Destination to the Address Book.
Registering Destinations to the Address Book (Remote UI)(P. 172)
Check Whether the Fax That Could Not Be Forwar
ded Is Saved in the Memory.
If the fax is saved in the memory, you can try forwarding it again.
Checking Faxes that Failed to Be
Forwar
ded(P. 289)
Troubleshooting
638
To Next Page
Loading...
Need help?
General
