83
Adding Shot Marks while Recording
Adding Shot Marks while Recording
When recording, you can flag an important shot in a clip by adding a “shot mark” (n). There are two types of
shot marks, shot mark 1 (c) and shot mark 2 (d), and you can add either or both types to a single clip. When
the camcorder is in mode, you can add or delete shot marks (0 119). You can also display an index
screen of all the shot marks (0 118), allowing you to find a particular scene in a clip more quickly.
To add a shot mark to a clip while recording, you must first set in advance an assignable button to [Add Shot
Mark 1] or [Add Shot Mark 2]. You can also press the SHOT1 button on the wireless controller to add the c
mark.
1 Set an assignable button to [Add Shot Mark 1] or [Add Shot Mark 2] (0 94).
• To add both shot marks, set one assignable button to [Add Shot Mark 1] and another assignable button to
[Add Shot Mark 2].
2 While you are recording, press the assignable button at the beginning of the shot you wish to mark.
• A message indicating the short mark will appear and the selected shot mark will be added to the current
frame of the clip.
• You can press the button again to add another shot mark. Up to 100 shot marks (c and d marks
combined) can be added to a single clip.
NOTES
• There may be up to a 0.5 second delay from when you press the button to when the camcorder adds the shot
mark.
• When you are using interval recording or frame recording mode, you cannot add shot marks to a clip.
• When a clip contains either shot mark, n will appear next to the clip’s thumbnail in the playback index screen.
Operating modes:
To Next Page
Loading...
Need help?
General
Weight and Dimensions
