20070201
3-1-5
Inputting and Editing a List
k Naming a List
You can assign List 1 through List 26 “sub names” of up to eight bytes each.
u To name a list
1. On the Setup screen, highlight “Sub Name” and then press 1(On)J.
2. Use the cursor keys to move the highlighting to the SUB cell of the list you want to
name.
3. Type in the name and then press w.
• To type in a name using alpha characters, press !a to enter the ALPHA-LOCK
mode.
Example: YEAR
-(Y)c(E)v(A)g(R)
• The following operation displays a sub name in the RUN
•
MAT mode.
!b(List) n !+( [ )a!-( ] )w
(
n = list number from 1 to 26)
# Though you can input up to 8 bytes for the
sub name, only the characters that can fi t
within the List Editor cell will be displayed.
# The List Editor SUB cell is not displayed when
“Off” is selected for “Sub Name” on the Setup
screen.
To Next Page
Loading...
Need help?
General
