20070201
k Calling Up List Editor
You can call up List Editor to input a list into a math line on the eActivity workspace screen.
Note
The data you create by calling up the List Editor using the procedure below can be used
in the calculation line on the eActivity workspace screen only. It is different from and
independent of data you create by calling up the List Editor from a strip or from the
RUN
•
MAT mode.
u To call up List Editor
Perform one of the following operations on the eActivity workspace screen.
To call up List Editor while the cursor is
located here:
Perform this key operation:
In a text line
6(g)6(g)2('LIST)
In a math line
6(g)4('LIST)
In a strip
6(g)4('LIST)
u To return to the eActivity workspace screen from List Editor
Press J.
u To use List Editor
List Editor operations are identical to those you perform when you call it up from the STAT
mode.
See “3. List Function” and “Inputting Data into Lists” (page 6-1-1) for information about
inputting data to List Editor and performing List Editor calculations.
10-4-2
Using Matrix Editor and List Editor
# The function menu arrangement when
you call up List Editor from the eActivity
workspace screen is slightly different from
the function menu arrangement when you
call it up from the STAT mode. The functions,
however, are identical.
Initial Function Menu
1(TOOL) Function Submenu
To Next Page
Loading...
Need help?
General
