20070201
8-1 Basic Programming Steps
Description
Commands and calculations are executed sequentially, just like manual calculation
multistatements.
Set Up
1. From the Main Menu, enter the PRGM mode. When you do, a program list appears on
the display.
Selected program area
(use f and c to move)
Files are listed in the alphabetic sequence of their
names.
Execution
2. Register a fi le name.
3. Input the program.
4. Run the program.
8-1-1
Basic Programming Steps
# If there are no programs stored in memory
when you enter the PRGM mode, the
message “No Programs” appears on the
display and only the NEW item (3) is shown
in the function menu.
# The values to the right of the program list
indicate the number of bytes used by each
program.
# A fi le name can be up to eight characters long.
# The following are the characters you can use in
a fi le name:
A through Z, r ,
θ
, spaces, [, ], {, }, ’, ”, ~,
0 through 9, ., +, –, ×, ÷
# Registering a fi le name uses 32 bytes of
memory.
# The fi le name input screen remains on the
display if you press w without inputting a fi le
name.
# To exit the fi le name input screen and return to
the program list without registering a fi le name,
press J.
To Next Page
Loading...
Need help?
General
