20070201
12-2 Connecting the Unit to a Personal
Computer
You can use the USB cable that comes with the calculator to connect it to a computer to
exchange images and other data.
For details on operation, the types of computer that can be connected, and hardware
limitations, see the user’s documentation for the FA-124 software that comes with the
calculator.
Some types of data may not be able to be exchanged with a personal computer.
u To connect the unit to a personal computer
1. Check to make sure that the power of the unit and the personal computer is off.
2. Connect the USB cable to your computer.
3. Connect the other end of the USB cable to the calculator.
4. Turn on the power of the unit, followed by the personal computer.
5. Perform the following procedure on the calculator to specify USB as the cable type.
(1) From the Main Menu, enter the LINK mode.
(2) Press 4(CABL). This displays the cable type selection screen.
(3) Press 1(USB).
Example: Connecting an fx-9860G calculator to a computer
• After you fi nish data communications, turn off power in the sequence: the unit fi rst, and
then the personal computer. Finally, disconnect the equipment.
12-2-1
Connecting the Unit to a Personal Computer
# The fx-9860G SD/fx-9860G/fx-9860G AU/
fx-9860G Slim also supports to PC transfer
of programs created with a CASIO CFX-9850
series calculator.
# For information about computer system
requirements, see the FA-124 User’s Guide.
To Next Page
Loading...
Need help?
General
