Cisco 4500M User Manual

9-4
Software Configuration Guide—Release 12.2(25)EW
OL-6696-01
Chapter 9 Configuring Switches with Web-based Tools
Configuring and Using the Network Assistant
When you initiate the installer, follow the displayed instructions. In the final panel, click Finish to
complete the installation of Network Assistant.
Overview of the CLI Commands
Table 3 is an overview of the Network Assistant-related CLI commands.
[
Configuring the Cisco Device for Use with Network Assistant
Before you can access the Network Assistant, you need to perform the following tasks:
• Enable Communication with Network Assistant, page 9-4
• Enable Intra-Cluster Communication, page 9-7
Enable Communication with Network Assistant
Network Assistant communicates with a Catalyst 4500 series switch by sending Cisco IOS commands
over a HTTP connection.
To enable Network Assistant to connect to a Catalyst 4500 series switch, perform this task on the switch:
Table 3 CLI Commands
Command Functions
[no] ip http server Configures the HTTP server on the switch.
[no] ip http port port_number Configures the HTTP port.
show version Displays the Cisco IOS version.
show running-config Displays the switch configuration.
[no] ip http authentication
{enable | local | tacacs}
Configures the HTTP authentication.
cluster run Enables clustering.
Command Purpose
Step 1
Switch# configure terminal
Enters global configuration mode.
Step 2
Switch(config)# ip http server
Enables the HTTP server on the switch.
By default, the HTTP server is disabled.
Step 3
Switch(config)# interface {vlan vlan_ID |
{fastethernet | gigabitethernet}
slot/interface | Port-channel number }
Selects an interface.

Cisco 4500M Specifications

General

Brand	Cisco
Model	4500M
Category	Network Router
Language	English