Cisco 4500M User Manual

21-3
Software Configuration Guide—Release 12.2(25)EW
OL-6696-01
Chapter 21 Configuring UDLD
Configuring UDLD on the Switch
Enabling UDLD Globally
To enable UDLD globally on all fiber-optic interfaces on the switch, perform this task:
Enabling UDLD on Individual Interfaces
To enable UDLD on individual interfaces, perform this task:
Disabling UDLD on Nonfiber-Optic Interfaces
To disable UDLD on individual nonfiber-optic interfaces, perform this task:
Command Purpose
Switch(config)# [no] udld enable
Enables UDLD globally on fiber-optic interfaces on the
switch.
Use the no keyword to globally disable UDLD on fiber-optic
interfaces.
Note This command configures only fiber-optic interfaces.
An individual interface configuration overrides the
setting of this command.
Command Purpose
Step 1
Switch(config-if)# udld enable
Enables UDLD on a specific interface. On a fiber-optic
interface, this command overrides the udld enable global
configuration command setting.
Step 2
Switch# show udld interface
Verifies the configuration.
Command Purpose
Step 1
Switch(config-if)# no udld enable
Disables UDLD on a nonfiber-optic interface.
Note On fiber-optic interfaces, the no udld enable
command reverts the interface configuration to
the udld enable global configuration command
setting.
Step 2
Switch# show udld interface
Verifies the configuration.

Cisco 4500M Specifications

General

Brand	Cisco
Model	4500M
Category	Network Router
Language	English