CHAPTER
2-1
Software Configuration Guide—Release 12.2(25)EW
OL-6696-01
2
Command-Line Interfaces
This chapter describes the CLIs you use to configure the Catalyst 4500 series switch. This chapter
includes the following major sections:
• Accessing the Switch CLI, page 2-1
• Performing Command-Line Processing, page 2-3
• Performing History Substitution, page 2-3
• Understanding Cisco IOS Command Modes, page 2-4
• Getting a List of Commands and Syntax, page 2-5
• ROMMOM Command-Line Interface, page 2-6
Note For complete syntax and usage information for the commands used in this chapter, refer to the
Catalyst 4500 Series Switch Cisco IOS Command Reference and related publications at
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/index.htm
Accessing the Switch CLI
The following sections describe how to access the switch CLI:
• Accessing the CLI Using the EIA/TIA-232 Console Interface, page 2-1
• Accessing the CLI Through Telnet, page 2-2
Accessing the CLI Using the EIA/TIA-232 Console Interface
Note EIA/TIA-232 was known as recommended standard 232 (RS-232) before its acceptance as a standard by
the Electronic Industries Alliance (EIA) and Telecommunications Industry Association (TIA).
Perform the initial switch configuration over a connection to the EIA/TIA-232 console interface. Refer
to the Catalyst 4500 Series Switch Module Installation Guide for console interface cable connection
procedures.
To Next Page
Loading...
Need help?
General
