EasyManuals Logo
Home>Cisco>Network Router>ASR 1001-X

Cisco ASR 1001-X User Manual

Cisco ASR 1001-X
152 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #100 background imageLoading...
Page #100 background image
When you install the unit, the ground connection must always be made first and disconnected last. Statement
1046
Danger
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1003
Danger
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Danger
Removing AC Power Supplies from the Cisco ASR 1001-X Router
This section describes how to remove an AC power supply from the Cisco ASR 1001-X Router. The Cisco
ASR 1001-X Router has two power supply slots, power supply slot 0 (PS0) next to the Standby switch and
power supply slot 1 (PS1) to the right, as shown in the below figures.
The Cisco ASR 1001-X Router has redundant power supplies that can be hot-swapped.Note
Follow these steps to remove an AC power supply from the Cisco ASR 1001-X Router:
SUMMARY STEPS
1.
At the rear of the router, ensure that the power switch is in the Standby position.
2.
Unplug the power cable from the power supply as shown in the below figure.
3.
Press the retaining latch towards the pull handle, grasp the handle with one hand, and pull the power supply
out of the slot while supporting the weight of the power supply with the other hand, as shown in the below
figure.
4.
Repeat these steps if it is required to remove the other AC power supply.
DETAILED STEPS
Step 1
At the rear of the router, ensure that the power switch is in the Standby position.
It is not required to place the power switch in the Standby position if you want to hot-swap a single power
supply.
Note
Cisco ASR 1001-X Router Hardware Installation Guide
92
Removing and Replacing FRUs from the Cisco ASR 1001-X Router
Removing AC Power Supplies from the Cisco ASR 1001-X Router

Table of Contents

Other manuals for Cisco ASR 1001-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 1001-X and is the answer not in the manual?

Cisco ASR 1001-X Specifications

General IconGeneral
Product colorGray
Rack capacity1U
Rack mountingYes
Networking standards-
Ethernet LAN (RJ-45) ports6
Installed SFP modules quantity2
Flash memory1024 MB
Internal memory8192 MB
Processor cores4
AC input voltage85 - 264 V
Power source typeAC
Power consumption (typical)250 W
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)0 - 50 °C
Storage relative humidity (H-H)5 - 95 %
Operating relative humidity (H-H)5 - 90 %
Security algorithmsAES
Weight and Dimensions IconWeight and Dimensions
Depth461.5 mm
Width439.42 mm
Height43.43 mm
Weight10590 g

Related product manuals