Cisco ASR 1001-X User Manual

.
end
Step 10
Respond to the following prompts. Select [2] to save the initial configuration.
Example:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started! RETURN
The following user prompt is displayed:
Example:
myrouter>
Completing the Configuration
When using the Cisco setup command facility, and after you have provided all the information requested by
the facility as described in Using the Cisco setup Command Facility, on page 50, the final configuration
appears. To complete your router configuration, follow these steps:
SUMMARY STEPS
1.
The facility prompts you to save the configuration.
2.
When messages stop appearing on your screen, press Return to get the Router> prompt.
3.
The Router> prompt indicates that you are now at the command-line interface (CLI) and you have just
completed an initial router configuration. Note that this is not a complete configuration. At this point, you
have two choices:
DETAILED STEPS
Step 1
The facility prompts you to save the configuration.
•
If you answer no, the configuration information you entered is not saved, and you return to the router enable prompt
(Router#). Enter setup to return to the System Configuration dialog box.
•
If you answer yes, the configuration is saved, and you are returned to the user EXEC prompt (Router>).
Example:
Use this configuration? {yes/no} : yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
%LINK-3-UPDOWN: Interface GigabitEthernet0/1/0, changed state to up
Cisco ASR 1001-X Router Hardware Installation Guide
53
Cisco ASR 1001-X Router Power Up and Initial Configuration
Using the Cisco setup Command Facility

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g