Cisco ASR 1001-X User Manual

Cisco ASR 1001-X Router Power Supplies
The Cisco ASR 1001-X Router supports AC and DC power supply options. The modular chassis configurations
support the installation of two power supplies for redundancy. When an external power supply fails or is
removed, the other power supply provides power requirements for the chassis. This allows you to hot-swap
the power supply without impacting the functionality of the router.
Power Supplies for the Cisco ASR 1001-X Router
Each Cisco ASR 1001-X Router power supply provides 250 W of output power. The power supplies are used
in a 1 + 1 redundant configuration. There is no input switch on the faceplate of the power supplies. A power
supply is switched from Standby to On by way of a system chassis STANDBY/ON switch. When facing the
rear of the chassis, power supply slot 0 (PS0) is to the left (next to the power supply standby switch) and
power supply slot 1(PS1) is to the right.
The Cisco ASR 1001-X Router supports the following power supplies:
• Cisco ASR 1001-X Router AC power supply—Provides 250 W output power with DC voltage output
of +12 V. The AC power supply operates between +85 and +264 VAC. The AC power supply current
shares on the 12 V output and is used in a dual hot pluggable configuration.
• Cisco ASR 1001-X Router DC power supply—Provides 242 W output power with DC voltage output
of +12 V. The power supply operates between –40 and –72 VDC. The DC power supply current shares
on the 12 V output and is used in a dual hot-pluggable configuration.
The Cisco ASR 1001-X Router can support two AC or two DC power supplies. Do not install mixed AC
and DC power supply units in the same chassis.
Note
The following figure shows both the DC and AC power supplies for the Cisco ASR 1001-X Router.
Figure 6: Cisco ASR 1001-X Router DC Power Supply and AC Power Supply
Cisco ASR 1001-X Router Hardware Installation Guide
17
Cisco ASR 1001-X Router Supported Hardware Components
Cisco ASR 1001-X Router Power Supplies

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g