Cisco ASR 1001-X User Manual

Safety Warnings
Safety warnings appear throughout this publication in procedures that, if performed incorrectly, might harm
you. A warning symbol precedes each warning statement.
Before you install, configure, or perform maintenance on the router, review the documentation for the procedure
you are about to perform, paying special attention to the safety warnings.
Do not unpack the system until you are ready to install it. Keep the chassis in the shipping container to
prevent accidental damage until you determine an installation site. Use the appropriate unpacking
documentation included with the system.
Note
Read the installation instructions in this document before you connect the system to its power source. Failure
to read and follow these guidelines could lead to an unsuccessful installation and possibly damage the system
and components.
Safety Recommendations
The following guidelines will help to ensure your own safety and protect your Cisco equipment. This list does
not cover all potentially hazardous situations, so be alert .
•
Cisco safety policy mandates that all its routers must conform to the requirements of IEC 60950, with
appropriate national deviations, as a minimum. In addition, Cisco routers must also meet the requirements
of any other normative documents, for example, standards, technical specifications, laws or regulations.
•
Review the safety warnings listed in Regulatory Compliance and Safety Information for the Cisco ASR
1000 Series Aggregation Services Routers that accompanies your Cisco ASR 1001-X Router, before
installing, configuring, or maintaining the router.
•
Never attempt to lift an object that might be too heavy for you to lift by yourself.
•
Always turn all power supplies off and unplug all power cables before opening the chassis.
•
Always unplug the power cable before installing or removing a chassis.
•
Keep the chassis area clear and dust free during and after installation.
•
Keep tools and chassis components away from walk areas.
•
Do not wear loose clothing, jewelry (including rings and chains), or other items that could get caught
in the chassis. Fasten your tie or scarf and sleeves.
•
The Cisco ASR 1001-X Router operates safely when it is used in accordance with its marked electrical
ratings and product-usage instructions.
Compliance Requirements
This section includes Safety Compliance and Network Equipment Building Systems (NEBS) standards. The
Cisco ASR 1001-X Router is in compliance with national and international standards, as described in the
below table.
Cisco ASR 1001-X Router Hardware Installation Guide
25
Preparing Your Site for Installation
Safety Warnings

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g