Cisco ASR 1001-X User Manual

Removing and Replacing Cisco ASR 1001-X Router USB Flash
Memory Stick or Secure Token
The Cisco ASR 1001-X Router contains ports for a flash memory stick or a secure token, to store configurations
or Cisco IOS XE consolidated packages.
The below figure shows USB port 0 or 1 connector on the Cisco ASR 1001-X Router for the flash memory
stick or secure token.
Figure 16: Cisco ASR 1001-X Router FlashToken Memory Stick Port
Do not remove a USB Flash memory stick or secure token when issuing a file access command or a
read/write operation to the Flash memory stick or secure token when it is processing. The router might
reload or the USB Flash memory stick or secure token may get damaged. Prior to the removal of the USB
device, check to see if the USB activity LED on the front panel is flashing.
Caution
To remove and then replace a USB flash token memory stick from a Cisco ASR1001-X Router, follow these
steps:
SUMMARY STEPS
1.
Pull the flash memory stick or secure token from the USB port.
2.
To replace a Cisco USB Flash memory stick or secure token, insert the module into USB port 0 or 1, as
shown in the above figure. The Flash memory stick or secure token can be inserted only in one way, and
can be inserted or removed regardless of whether the router is powered up or not.
DETAILED STEPS
Step 1
Pull the flash memory stick or secure token from the USB port.
Step 2
To replace a Cisco USB Flash memory stick or secure token, insert the module into USB port 0 or 1, as shown in the
above figure. The Flash memory stick or secure token can be inserted only in one way, and can be inserted or removed
regardless of whether the router is powered up or not.
Cisco ASR 1001-X Router Hardware Installation Guide
101
Removing and Replacing FRUs from the Cisco ASR 1001-X Router
Removing and Replacing Cisco ASR 1001-X Router USB Flash Memory Stick or Secure Token

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g