Cisco ASR 1001-X User Manual

Step 6
Use a screwdriver to tighten the terminal block captive screws, as shown in the below figure.
Figure 15: DC Power Supply with Lead Wires
Positive (+) lead wire2
Negative (–) lead wire
1
Step 7
Repeat these steps for the remaining DC input power source wire as applicable.
Step 8
Use a tie wrap to secure the wires to the rack, so that the wires are not pulled from the terminal block by casual contact.
Step 9
Turn on the circuit breaker at the power source.
Step 10
If you have changed the Standby switch to the standby position in step 1, turn the Standby switch to the On position.
The power supply LEDs illuminate green.
What to Do Next
This completes the procedure for connecting the DC power supply in the Cisco ASR 1001-X Router.
Cisco ASR 1001-X Router Hardware Installation Guide
100
Removing and Replacing FRUs from the Cisco ASR 1001-X Router
Installing DC Input Power on the Cisco ASR 1001-X Router

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g