Cisco ASR 1001-X User Manual

• Power supply shutdown—The power supply detected an internal out-of-tolerance overvoltage, overcurrent,
or temperature condition and shut itself down. All DC power remains disabled until you toggle the power
switch.
The Cisco ASR 1001-X Router does not shut down automatically during an over-temperature condition. The
router will remain active irrespective of what the ambient temperature is, if the router is exposed to an extremely
hot environment for a prolonged period of time, it will remain active until the hardware fails.
The facility-alarm critical exceed-action shutdown command is disabled on the Cisco ASR 1001-X Router.
The console terminal displays the following error message if you execute the facility-alarm critical
exceed-action shutdown command:
Router(config)# facility-alarm critical exceed-action shutdown
Router(config)# end
Router#
*Apr 22 15:27:26.939: %CMANRPCHAIN-6-NOSHUTWARN: Shutdown not supported on this platform
*Apr 22 15:27:27.974: %SYS-5-CONFIG_I: Configured from console by console
Router#
If the air temperature exceeds a defined threshold, the system controller displays the following warning
message on the console terminal:
Router#
*Apr 22 15:30:37.749: %CMRP_ENVMON-3-TEMP_WARN_CRITICAL: R0/0: cmand: WARNING:
Temp: Inlet temperature sensor on R0 is in a critical state reading 81
Router#
The console terminal displays the following status if you execute the show facility-alarm status command:
Router# show facility-alarm status
System Totals Critical: 2 Major: 0 Minor: 0
Source Time Severity Description [Index]
------ ------ -------- -------------------
xcvr container 0/0/1 Apr 22 2014 15:25:57 CRITICAL Transceiver Missing - Link Down [1]
Temp: Inlet R0/30 Apr 22 2014 15:30:37 CRITICAL Temp Above Normal (Shutdown) [1]
GigabitEthernet0 Apr 22 2014 15:25:42 INFO Physical Port Administrative State Down [2]
Router#
Fan Failures
Four internal fans draw cooling air into the chassis and across internal components to maintain an acceptable
operating temperature. The fans are located in the center of the chassis. The fans are numbered from 0 to 3,
right to left. When the system power is on, all fans should be operational. However, the system continues to
operate even if a fan fails.
Use the show platform hardware slot <slot> fan status command to view the status of the fans, for example:
Router# show platform hardware slot P2 fan status
Cisco ASR 1001-X Router Hardware Installation Guide
65
Cisco ASR 1001-X Router Power Up and Initial Configuration
Fan Failures

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g