Cisco ASR 1001-X User Manual

Step 4
Ensure that the AC power cords are positioned, as shown in the below figure.
Figure 12: Correct Position of the Cisco ASR 1001-X Router AC Power Supply Cables
Position of power supply
cable
2AC power supply1
Step 5
If you have changed the Standby switch to the standby position in step 1, turn the Standby switch to the On position.
The power supply LEDs are illuminated (green).
What to Do Next
This completes the procedure for connecting AC input power.
Removing DC Input Power from the Cisco ASR 1001-X Router
The Cisco ASR 1001-X Router has redundant power supplies that can be hot-swapped.Note
This section describes how to remove a DC power supply from the Cisco ASR 1001-X Router. Follow these
steps:
SUMMARY STEPS
1.
Turn off the circuit breaker from the power source.
2.
At the rear of the router, ensure that the power switch is in the Standby position.
3.
Unscrew the two terminal block wire connectors (negative and positive) on the unit. See the below figure.
4.
Press the retaining latch towards the pull handle, grasp the handle with one hand, and pull the power supply
out of the slot while supporting the weight of the power supply with the other hand. See the below figure.
Cisco ASR 1001-X Router Hardware Installation Guide
96
Removing and Replacing FRUs from the Cisco ASR 1001-X Router
Removing DC Input Power from the Cisco ASR 1001-X Router

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g