Cisco ASR 1001-X User Manual

General Safety Warnings
Read the installation instructions before you connect the system to its power source. Statement 1004Danger
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Danger
No user-serviceable parts inside Do not open. Statement 1040Danger
Installation of the equipment must comply with local and national electrical codes. Statement 1074Danger
Shielded twisted pair T1/E1 cables must be used with the 8-port channelized T1/E1 SPA interfaces in any
Cisco ASR 1000 chassis. This is required for compliance with Class A emission requirements for EMC.
Danger
Shielded twisted pair T1/E1 cables must be used with any of the T1/E1 NIM interfaces in any Cisco ASR
1000 chassis. This is required for compliance with Class A emission requirements for EMC.
Danger
To comply with Class A emissions requirements- shielded management Ethernet, CON, and AUX cables
on the Cisco ASR 1001-X Router must be used.
Danger
Power cable and AC adapter - When installing the product, please use the provided or designated connection
cables/power cables/AC adapters. Using any other cables or adapters could cause a malfunction or a fire.
Electrical Appliance and Material Safety Law prohibits the use of certified cables (that have the ‘UL’
shown on the code) for any other electrical devices than products designated by Cisco. The use of cables
that are certified by Electrical Appliance and Material Safety Law (that have ‘PSE’ shown on the code) is
not limited to Cisco-designated products. Statement 371
Danger
Only trained and qualified personnel should be allowed to install or replace this equipmentStatement 1030Danger
Cisco ASR 1001-X Router Hardware Installation Guide
28
Preparing Your Site for Installation
General Safety Warnings

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g