Cisco ASR 1001-X User Manual

•
Always disconnect all external cables before lifting or moving the chassis.
Tools and Equipment
The following tools and equipment are recommended as the minimum necessary equipment to install the
Cisco ASR 1001-X Router. You may need additional tools and equipment to install associated equipment and
cables. You may also require test equipment to check electronic and optical signal levels, power levels, and
communications links.
•
Phillips hand screwdriver
•
3.5-mm flat-blade screwdriver
•
Tape measure (optional)
•
Level (optional)
•
Power drill
•
8-gauge wire
•
Rack-mount brackets
•
Cable-management brackets
Unpacking and Verifying Shipping Contents
When you receive your chassis, perform the following steps and use the shipping contents checklist from
Checking the Shipping Container Contents, on page 43.
SUMMARY STEPS
1.
Inspect the box for any shipping damage. (If there is damage, contact your Cisco service representative).
2.
Unpack the Cisco ASR 1001-X Router.
3.
Perform a visual inspection of the chassis.
4.
After you have unpacked the system, verify that you have received all of the required components, including
all the accessory items. Using the packing list as a guide, verify that you have received all the equipment
listed in your order, and ensure that the configuration matches the packing list.
DETAILED STEPS
Step 1
Inspect the box for any shipping damage. (If there is damage, contact your Cisco service representative).
Step 2
Unpack the Cisco ASR 1001-X Router.
Step 3
Perform a visual inspection of the chassis.
Step 4
After you have unpacked the system, verify that you have received all of the required components, including all the
accessory items. Using the packing list as a guide, verify that you have received all the equipment listed in your order,
and ensure that the configuration matches the packing list.
Cisco ASR 1001-X Router Hardware Installation Guide
42
Preparing Your Site for Installation
Tools and Equipment

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g