Cisco ASR 1001-X User Manual

DescriptionField Name
Indicates whether you are utilizing a permanent
(purchased) license, an evaluation 60-day license, or
a Right-to-Use license that would indicate that the
purchase of a license is required.
License Type: RightToUse
Indicates the startup configuration definition that will
be used for the next reload instance.
Next reload license Level: adventerprise
Use the show running-config command or the show startup-config command to view the license-level
information. The following example displays sample output from the show running-config command:
Router# show running-config
.
.
.
license boot level adventerprise
.
.
Table 19: show running-config Command Output Description
DescriptionField Name
Indicates the current requested Cisco lOS license level
to boot.
license boot level adventerprise
Configuring the Throughput Level
The built-in embedded service processor of the Cisco ASR 1001-X Router supports throughputs of 2.5 Gbps
(default), 5 Gbps, 10 Gbps, and 20 Gbps depending upon the software license.
You can upgrade the throughput of the ESP from 2.5 Gbps (default) to 5 Gbps, 10 Gbps, or 20 Gbps by
applying a software-activated performance upgrade license and then reloading the router. You can upgrade
the throughput of the ESP from any license level to another.
To determine the current throughput level of the ESP, run the show platform hardware throughput level
command. The following example shows the output from this command after you apply the 20 Gbps
performance upgrade license and reload the router:
Router# show platform hardware throughput level
The current throughput level is 2000000 kb/s
After the router is reloaded, the log messages at the router startup will display the license-level and
throughput-level information, for example:
Cisco ASR 1001-X Router Hardware Installation Guide
80
Cisco ASR 1001-X Router License Verification
Configuring the Throughput Level

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g