Cisco ASR 1001-X User Manual

Verifying the Initial Configuration
Enter the following commands in Cisco IOS-XE to verify the initial configuration on the router:
• show version—Displays the system hardware version, the installed software version, the names and
sources of configuration files, the boot images, and the amount of installed DRAM, NVRAM, and flash
memory.
• show diag—Lists and displays diagnostic information about the installed controllers, interface processors,
and port adapters.
• show interfaces— Shows if interfaces are operating correctly and if interfaces and line protocols are in
the correct state, either up or down
• show ip interface brief—Displays a summary of the interfaces configured for IP protocol.
• show configuration—Helps verify if you have configured the correct hostname and password.
After you have completed and verified the initial configuration, the specific features and functions are ready
to be configured. See the Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
.
Powering Off the Cisco ASR 1001-X Router Safely
This section explains how to shut down the Cisco ASR 1001-X Router. We recommend that before turning
off all power to the chassis, you issue the reload command. This ensures that the operating system cleans up
all the file systems.
To remove power from the Cisco ASR 1001-X Router safely, follow this procedure:
SUMMARY STEPS
1.
Slip on the ESD-preventive wrist strap included in the accessory kit.
2.
Enter the reload command.
3.
Confirm the reload command:
4.
After confirming the reload command, wait until the system bootstrap message is displayed before powering
off the system:
5.
Place the Standby switch in the Standby position.
DETAILED STEPS
Step 1
Slip on the ESD-preventive wrist strap included in the accessory kit.
Step 2
Enter the reload command.
Step 3
Confirm the reload command:
Example:
Router# reload
Proceed with reload? [confirm]
Cisco ASR 1001-X Router Hardware Installation Guide
62
Cisco ASR 1001-X Router Power Up and Initial Configuration
Verifying the Initial Configuration

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g