Cisco ASR 1001-X User Manual

%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/1/0, changed state to up
<Additional messages omitted.>
Step 2
When messages stop appearing on your screen, press Return to get the Router> prompt.
Step 3
The Router> prompt indicates that you are now at the command-line interface (CLI) and you have just completed an
initial router configuration. Note that this is not a complete configuration. At this point, you have two choices:
•
Run the setup command facility again, and create another configuration:
Example:
Router> enable
Password: password
Router# setup
•
Modify the existing configuration or configure additional features by using the CLI:
Example:
Router> enable
Password: password
Router# configure terminal
Router(config)#
Using the Cisco IOS-XE CLI--Manual Configuration
This section shows you how to access the CLI to perform the initial configuration on the router.
If the system configuration message does not appear, it means a default configuration file was installed on
the router prior to shipping. Follow these steps to configure the router.
SUMMARY STEPS
1.
Enter no when the following system message appears on the router:
2.
Press Return and continue with the manual configuration:
3.
Press Return to bring up the Router> prompt.
4.
Type enable to enter privileged EXEC mode:
DETAILED STEPS
Step 1
Enter no when the following system message appears on the router:
Example:
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2
Press Return and continue with the manual configuration:
Several log messages are displayed.
Cisco ASR 1001-X Router Hardware Installation Guide
54
Cisco ASR 1001-X Router Power Up and Initial Configuration
Using the Cisco IOS-XE CLI--Manual Configuration

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g