Cisco ASR 1001-X User Manual

Cisco ASR 1001-X Power Supply Fans
The fans in the power supply module of the Cisco ASR 1001-X Router are used for cooling the power supply
module itself while system-level cooling is provided by four fans within the chassis. The power supplies do
not depend on the system-level fans for cooling. Fan failure is determined by fan-rotation sensors.
The fans in the power supply modules will run as soon as the power supply is plugged in, even if the
Standby switch is in the Standby position.
Note
Cisco ASR 1001-X Router AC Power Supply
The Cisco ASR 1001-X Router has two AC power supplies in the rear of the chassis. The input receptacle is
an IEC60320 C14 type of filtered AC inlet. The current rating on the connector is 10 A. The following figure
shows the Cisco ASR 1001-X Router AC power supply.
Figure 7: Cisco ASR 1001-X Router AC Power Supply
AC power connector3Handle1
Retaining latch4FAIL and OK LEDs2
Cisco ASR 1001-X Router DC Power Supply
The Cisco ASR 1001-X Router DC input connector is a two-wire connector with connection polarity from
left to right (when facing the unit) of negative (–) positive (+).
Cisco ASR 1001-X Router Hardware Installation Guide
18
Cisco ASR 1001-X Router Supported Hardware Components
Cisco ASR 1001-X Power Supply Fans

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g