Cisco ASR 1001-X User Manual

It is not required to place the power switch in the Standby position if you want to hot-swap a single power
supply.
Note
Figure 11: Cisco ASR 1001-X Router AC Power Supply Standby Switch
Cisco ASR 1001-X Router Standby switch, which does
not disconnect power from the power source.
1
Step 2
Insert the power supply module into the appropriate slot(s), making sure that the retention latch is firmly placed. You
can verify that the power supply module is firmly latched by gently pulling the power supply handle.
Step 3
Insert the power supply cables firmly into the power supplies.
Ensure that both power supplies are inserted firmly and the power cords are in place.Note
Cisco ASR 1001-X Router Hardware Installation Guide
95
Removing and Replacing FRUs from the Cisco ASR 1001-X Router
Installing AC Power Supplies in the Cisco ASR 1001-X Router

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g