Cisco ASR 1001-X User Manual

SUMMARY STEPS
1.
Place the DIMM on an antistatic mat or pad while wearing an antistatic device, such as a wrist strap.
2.
Remove the new DIMM from the antistatic bag.
3.
Locate the polarization notch and align the DIMM with the socket before inserting it. See the below figure.
4.
Gently insert the new DIMM, taking care not to damage the pins on the edge of the DIMM. Using two
hands, hold both sides of DIMM’s top edges with your index fingers and thumbs and gently slide the
DIMM straight in to the socket. Press the top of the DIMM towards the socket, being careful to apply
force only on the DIMM that is parallel with the plane of the DIMM.
5.
Use light insertion force and insert smoothly, but ensure that the DIMM is inserted straight. If necessary,
rock the DIMM gently back and forth to seat it properly. The following figure shows how to install the
DIMM in the socket for the Cisco ASR 1001-X Router.
6.
After the DIMM is installed, check whether the release levers are flush against the sides of the DIMM
socket. If they are not, the DIMM might not be seated properly. If the DIMM appears misaligned, carefully
remove it according to the removal procedure and then reseat it in the socket. Push the DIMM firmly back
into the socket until the release levers are flush against the sides of the DIMM socket.
7.
Repeat Step 4 through Step 6 for the remaining DIMM.
8.
Replace the Cisco ASR 1001-X Router top cover:
9.
Install the power supplies into the chassis. See:
DETAILED STEPS
Step 1
Place the DIMM on an antistatic mat or pad while wearing an antistatic device, such as a wrist strap.
DIMMs are sensitive components that can be shorted by mishandling; they are susceptible to ESD damage.
Handle the DIMM by the edges only, and avoid touching the pins.
Caution
Step 2
Remove the new DIMM from the antistatic bag.
Step 3
Locate the polarization notch and align the DIMM with the socket before inserting it. See the below figure.
Figure 20: Cisco ASR 1001-X Router DIMM Polarization Notch
Step 4
Gently insert the new DIMM, taking care not to damage the pins on the edge of the DIMM. Using two hands, hold both
sides of DIMM’s top edges with your index fingers and thumbs and gently slide the DIMM straight in to the socket.
Press the top of the DIMM towards the socket, being careful to apply force only on the DIMM that is parallel with the
plane of the DIMM.
Cisco ASR 1001-X Router Hardware Installation Guide
106
Removing and Replacing FRUs from the Cisco ASR 1001-X Router
Removing and Replacing the Cisco ASR 1001-X Router DIMM Memory Module

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g