Cisco SCE 8000 User Manual

6-13
Cisco SCE8000 GBE Installation and Configuration Guide
Chapter 6 Cabling the Line Ports and Completing the Installation
How to Cable the 10 GBE Line Interface Ports
How to Cable the 10 GBE Line Interface Ports
Step 1 Take the appropriate fiber optic cable (see XFP Module Cabling and Connection Equipment, page 6-11)
and plug it into the appropriate port on the 10 GBE interface on the SPA module in slot #3 of the Cisco
SCE 8000. (See Figure 6-1.)
Make sure to push on the connector until you hear a click, which indicates that the connector is fully
inserted and secured in the receptacle. Always make sure that you insert the connector completely into
the socket.
Figure 6-1 Cabling the 10 GBE Interface
Step 2
Verify that the link LED is green.
If the link LED does not light, try removing the network cable plug and reinserting it firmly into the
module socket.
270979
SCE8000-SIP
STA
TUS
AC
T
IVE/LIN
K
SPA-1X
1
0GE-L-V2
S
TA
TU
S
A
C
T
IV
E/
L
IN
K
SPA-1X
1
0GE-L-V2

Cisco SCE 8000 Specifications

General

Brand	Cisco
Model	SCE 8000
Category	Switch
Language	English