Cisco SCE 8000 User Manual

9-28
Cisco SCE8000 GBE Installation and Configuration Guide
Chapter 9 Removal and Replacement Procedures
Installation and Upgrade Procedures for Dual Cisco SCE 8000-SCM Modules
Downgrading Dual Cisco SCE 8000-SCM Modules
Downgrading the system to a version earlier than 3.6.0 is not permitted on a system with dual Cisco SCE
8000-SCM modules.
Perform the following steps to downgrade:
Step 1 At the SCE8000# prompt, enter reload shutdown and press Enter and then turn off the
Cisco SCE 8000 10 GBE platform.
Step 2 Remove the Cisco SCE 8000-SCM module in slot 2.
Step 3 Turn on the Cisco SCE 8000 power.
Step 4 Perform the downgrade.
Upgrading Dual Cisco SCE 8000-SCM Modules
Use the Upgrade wizard in the Cisco SCA BB console to upgrade a system with dual Cisco SCE
8000-SCM modules the same as for a single Cisco SCE 8000-SCM module system. See the How to
Upgrade the SCE Using the SCE Software Upgrade Wizard section in the Cisco Service Control
Application for Broadband User Guide.

Cisco SCE 8000 Specifications

General

Brand	Cisco
Model	SCE 8000
Category	Switch
Language	English