Cisco SCE 8000 User Manual

1
Cisco SCE8000 GBE Installation and Configuration Guide
About this Guide
Revised: August 26, 2014
Introduction
This preface describes who should read Cisco SCE 8000 10 GBE Installation and Configuration Guide,
how it is organized, and its document conventions.
This guide is for the networking or computer technician responsible for installing and configuring the
Cisco SCE 8000 platform on-site. To use this publication, you should be familiar with
telecommunications equipment and installation procedures, as well as electronic circuitry and wiring
practices. You should also have experience as an electronic or electromechanical technician.
This installation guide explains the initial hardware installation and basic configuration procedures for
the Cisco SCE 8000. It contains procedures for unpacking and installing the device and performing basic
configuration via the setup wizard. After completing the installation and basic configuration procedures
covered in this guide, use the appropriate companion publications to configure your system.
This guide contains instructions on how to install and run the Cisco SCE 8000 platform. This guide
assumes a basic familiarity with telecommunications equipment and installation procedures.

Cisco SCE 8000 Specifications

General

Brand	Cisco
Model	SCE 8000
Category	Switch
Language	English