7-20
Cisco SCE8000 GBE Installation and Configuration Guide
Chapter 7 Basic Cisco SCE 8000 Platform Operations
Rebooting and Shutting Down the SCE Platform
Rebooting and Shutting Down the SCE Platform
This section describes the following topics:
• Rebooting the SCE Platform, page 7-20
• How to Shut Down the SCE Platform, page 7-20
Rebooting the SCE Platform
Rebooting the SCE platform is required after installing a new package, in order for that package to take
effect. There might be other occasions where rebooting the SCE platform is necessary.
Note When the SCE restarts, it loads the startup configuration, so all changes made in the running
configuration are lost. Save the running configuration before performing reload, as described in Saving
or Changing the Configuration Settings, page 7-8.
Step 1 At the SCE8000# prompt, enter reload and press Enter.
A confirmation message appears.
Step 2 Enter y to confirm the reboot request and press Enter.
Examples for Rebooting the SCE Platform
The following example shows the commands for system reboot:
SCE8000# reload
Are you sure? y
the system is about to reboot, this will end your CLI session
How to Shut Down the SCE Platform
Shutting down the SCE platform is required before turning the power off. This helps to ensure that
non-volatile memory devices in the SCE platform are properly flushed in an orderly manner.
Note When the SCE platform restarts, it loads the startup configuration, so all changes made in the running
configuration are lost. Save the running configuration before performing reload, as described in Saving
or Changing the Configuration Settings, page 7-8.
Step 1 Connect to the serial console port (The CON connector on the front panel of the Service Control module
in slot 1, 9600 baud).
The SCE8000# prompt appears.
Step 2 Enter reload shutdown.
A confirmation message appears.
To Next Page
Loading...
Need help?
General
