4-31
Cisco Wireless LAN Controller Configuration Guide
Ol-9141-03
Chapter 4 Configuring Controller SettingsWireless Device Access
Configuring Voice and Video Parameters
Step 4 To enable or disable voice CAC for the 802.11a or 802.11b/g network, enter this command:
config {802.11a | 802.11b} cac voice acm {enable | disable}
Step 5 To set the percentage of maximum bandwidth allocated to clients for voice applications on the 802.11a
or 802.11b/g network, enter this command:
config {802.11a | 802.11b} cac voice max-bandwidth bandwidth
The bandwidth range is 40 to 85%, and the default value is 75%. Once the client reaches the value
specified, the access point rejects new calls on this network.
Step 6 To set the percentage of maximum allocated bandwidth reserved for roaming voice clients, enter this
command:
config {802.11a | 802.11b} cac voice roam-bandwidth bandwidth
The bandwidth range is 0 to 25%, and the default value is 6%. The controller reserves this much
bandwidth from the maximum allocated bandwidth for roaming voice clients.
Step 7 To enable or disable TSM for the 802.11a or 802.11b/g network, enter this command:
config {802.11a | 802.11b} tsm {enable | disable}
Step 8 To enable the radio network, enter this command:
config {802.11a | 802.11b} enable network
Step 9 To save your settings, enter this command:
save config
Using the CLI to Configure Video Parameters
Follow these steps to configure video parameters using the CLI.
Step 1 Make sure that the WLAN is configured for WMM and the QoS level is set to Gold. See “Configuring
Quality of Service” section on page 6-17 for instructions.
Step 2 To disable the radio network, enter this command:
config {802.11a | 802.11b} disable network
Step 3 To save your settings, enter this command:
save config
Step 4 To enable or disable video CAC for the 802.11 or 802.11b/g network, enter this command:
config {802.11a | 802.11b} cac video acm {enable | disable}
Step 5 To set the percentage of maximum bandwidth allocated to clients for video applications on the 802.11a
or 802.11b/g network, enter this command:
config {802.11a | 802.11b} cac video max-bandwidth bandwidth
The bandwidth range is 0 to 100%, and the default value is 0%. However, the maximum RF bandwidth
cannot exceed 100% for voice + video. Once the client reaches the value specified, the access point
rejects new calls on this network.
To Next Page
Loading...
Need help?
General
