Cisco SD2008T-NA User Manual

5-9
Cisco Wireless LAN Controller Configuration Guide
OL-9141-03
Chapter 5 Configuring Security Solutions
Configuring Access Control Lists
Using the GUI to Configure Access Control Lists
Follow these steps to configure ACLs using the controller GUI.
Step 1 Click Security > Access Control Lists to access the Access Control Lists page (see Figure 5-2).
Figure 5-2 Access Control Lists Page
This page lists all of the ACLs that have been configured for this controller. It also enables you to edit
or remove any of the ACLs.
Step 2 To add a new ACL, click New. The Access Control Lists > New page appears (see Figure 5-3).
Figure 5-3 Access Control Lists > New Page
Step 3
In the Access Control List Name field, enter a name for the new ACL. You can enter up to 32
alphanumeric characters.
Step 4 Click Apply. When the Access Control Lists page reappears, click the Edit link for the new ACL.

Cisco SD2008T-NA Specifications

General

Brand	Cisco
Model	SD2008T-NA
Category	Extender
Language	English