B-2
Cisco Wireless LAN Controller Configuration Guide
Ol-9141-03
Appendix B Declarations of Conformity and Regulatory Information
Regulatory Information for 1000 Series Access Points
Regulatory Information for 1000 Series Access Points
This section contains regulatory information for 1000 series access points. The information is in these
sections:
• Manufacturers Federal Communication Commission Declaration of Conformity Statement, page
B-2
• Department of Communications—Canada, page B-3
• European Community, Switzerland, Norway, Iceland, and Liechtenstein, page B-4
• Declaration of Conformity for RF Exposure, page B-5
• Guidelines for Operating Cisco Aironet Access Points in Japan, page B-6
• Administrative Rules for Cisco Aironet Access Points in Taiwan, page B-7
• Declaration of Conformity Statements, page B-8
Manufacturers Federal Communication Commission Declaration of Conformity
Statement
Model:
AIR-AP1010-A-K9, AIR-AP1020-A-K9, AIR-AP1030-A-K9
FCC Certification number:
LDK102057
Manufacturer:
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
This device complies with Part 15 rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a residential environment. This equipment generates,
uses, and radiates radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference. However, there is no guarantee that interference will not
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
To Next Page
Loading...
Need help?
General
