3-17
Cisco Wireless LAN Controller Configuration Guide
OL-9141-03
Chapter 3 Configuring Ports and Interfaces
Configuring Dynamic Interfaces
Step 5 Configure the following parameters:
• VLAN identifier
• Fixed IP address, IP netmask, and default gateway
• Physical port assignment
• Quarantine
Note Check the Quarantine check box if you want to configure this VLAN as unhealthy. Doing
so causes the data traffic of any client that is assigned to this VLAN to pass through the
controller, even if the WLAN is configured for local switching. This command is generally
used for clients that are associated to a hybrid-REAP access point and the access point’s
controller is configured for network access control (NAC). See Chapter 12 for more
information on hybrid REAP.
• Primary and secondary DHCP servers
• Access control list (ACL) name, if required
Note See Chapter 5 for more information on ACLs.
Note To ensure proper operation, you must set the Port Number and Primary DHCP Server
parameters.
Step 6 Click Save Configuration to save your changes.
Step 7 Repeat this procedure for each dynamic interface that you want to create or edit.
Using the CLI to Configure Dynamic Interfaces
Follow these steps to configure dynamic interfaces using the CLI.
Step 1 Enter show interface summary to view the current dynamic interfaces.
Step 2 To view the details of a specific dynamic interface, enter show interface detailed
operator-defined-interface-name.
Step 3 Enter config wlan disable wlan-number to disable each WLAN that uses the dynamic interface for
distribution system communication.
To Next Page
Loading...
Need help?
General
