12-15
Cisco Wireless LAN Controller Configuration Guide
OL-9141-03
Chapter 12 Configuring Hybrid REAPWireless Device Access
Configuring Hybrid REAP
Using the CLI to Configure an Access Point for Hybrid REAP
Use these commands on the controller to configure an access point for hybrid REAP:
• config ap mode h-reap Cisco_AP—Enables hybrid REAP for this access point.
• config ap h-reap vlan wlan wlan_id vlan-id Cisco_AP—Enables you to assign a VLAN ID to this
hybrid-REAP access point. By default, the access point inherits the VLAN ID associated to the
WLAN.
• config ap h-reap vlan {enable | disable} Cisco_AP—Enables or disables VLAN tagging for this
hybrid-REAP access point. By default, VLAN tagging is not enabled. Once VLAN tagging is
enabled on the hybrid-REAP access point, WLANs enabled for local switching inherit the VLAN
assigned at the controller.
• config ap h-reap vlan native vlan-id Cisco_AP—Enables you to configure a native VLAN for this
hybrid-REAP access point. By default, no VLAN is set as the native VLAN. One native VLAN must
be configured per hybrid-REAP access point (when VLAN tagging is enabled). Make sure the
switchport to which the access point is connected has a corresponding native VLAN configured as
well. If the hybrid-REAP access point’s native VLAN setting and the upstream switchport native
VLAN do not match, the access point cannot transmit packets to and from the controller.
Use these commands on the hybrid-REAP access point to obtain status information:
• show lwapp reap status—Shows the status of the hybrid-REAP access point (connected or
standalone).
• show lwapp reap association—Shows the list of clients associated to this access point and their
SSIDs.
Use these commands on the hybrid-REAP access point to obtain debug information:
• debug lwapp reap—Shows general hybrid-REAP activities.
• debug lwapp reap mgmt—Shows client authentication and association messages.
• debug lwapp reap load—Shows payload activities, which is useful when the hybrid-REAP access
point boots up in standalone mode.
• debug dot11 mgmt interface—Shows 802.11 management interface events.
• debug dot11 mgmt msg—Shows 802.11 management messages.
• debug dot11 mgmt ssid—Shows SSID management events.
• debug dot11 mgmt state-machine—Shows the 802.11 state machine.
• debug dot11 mgmt station—Shows client events.
To Next Page
Loading...
Need help?
General
