Cisco SD2008T-NA User Manual

6-18
Cisco Wireless LAN Controller Configuration Guide
OL-1926-06OL-9141-03
Chapter 6 Configuring WLANsWireless Device Access
Configuring WLANs
Configuring QoS Enhanced BSS (QBSS)
You can enable QBSS in these two modes:
• Wireless Multimedia (WMM) mode, which supports devices that meet the 802.11E QBSS standard
• 7920 support mode, which supports Cisco 7920 IP telephones on your 802.11b/g network
QBSS is disabled by default.
Enabling WMM Mode
Enter this command to enable WMM mode:
config wlan wmm {disabled | allowed | required} wlan-id
• The allowed option allows client devices to use WMM on the WLAN.
• The required option requires client devices to use WMM; devices that do not support WMM cannot
join the WLAN.
Note Do not enable WMM mode if Cisco 7920 phones are used on your network.
Table 6-1 Access Point QoS Translation Values
AVVID 802.1p UP-Based
Traffic Type AVVID IP DSCP AVVID 802.1p UP IEEE 802.11e UP
Network control – 7 –
Inter-network control
(LWAPP control,
802.11 management)
48 6 7
Vo i c e 4 6 ( E F ) 5 6
Video 34 (AF41) 4 5
Voice control 26 (AF31) 3 4
Background (Gold) 18 (AF21) 2 2
Background (Gold) 20 (AF22) 2 2
Background (Gold) 22 (AF23) 2 2
Background (Silver) 10 (AF11) 1 1
Background (Silver) 12 (AF12) 1 1
Background (Silver) 14 (AF13) 1 1
Best Effort 0 (BE) 0 0, 3
Background 2 0 1
Background 4 0 1
Background 6 0 1

Cisco SD2008T-NA Specifications

General

Brand	Cisco
Model	SD2008T-NA
Category	Extender
Language	English