Cisco SD2008T-NA User Manual

9-4
Cisco Wireless LAN Controller Configuration Guide
OL-9141-03
Chapter 9 Managing User Accounts
Creating Guest User Accounts
Using the CLI to Create a Lobby Ambassador Account
Enter this command to create a lobby ambassador account using the controller CLI:
config mgmtuser add lobbyadmin_username lobbyadmin_pwd lobby-admin
Note Replacing lobby-admin with read-only creates an account with read-only privileges. Replacing
lobby-admin with read-write creates an administrative account with both read and write privileges.
Creating Guest User Accounts as a Lobby Ambassador
A lobby ambassador would follow these steps to create guest user accounts.
Note A lobby ambassador cannot access the controller CLI interface and therefore can create guest user
accounts only from the controller GUI.
Step 1 Log into the controller as the lobby ambassador, using the username and password specified in the
“Creating a Lobby Ambassador Account” section above. The Lobby Ambassador Guest Management >
Guest Users List page appears (see Figure 9-3).
Figure 9-3 Lobby Ambassador Guest Management > Guest Users List Page
Step 2
Click New to create a guest user account. The Lobby Ambassador Guest Management > Guest Users
List > New page appears (see Figure 9-4).
Figure 9-4 Lobby Ambassador Guest Management > Guest Users List > New Page

Cisco SD2008T-NA Specifications

General

Brand	Cisco
Model	SD2008T-NA
Category	Extender
Language	English