Cisco SD2008T-NA User Manual

6-34
Cisco Wireless LAN Controller Configuration Guide
OL-1926-06OL-9141-03
Chapter 6 Configuring WLANsWireless Device Access
Configuring WLANs
Using the GUI to Configure Conditional Web Redirect
Follow these steps to configure conditional web redirect using the controller GUI.
Step 1 Click WLANs to access the WLANs page.
Step 2 Click the Edit link for the desired WLAN. The WLANs > Edit page appears (see Figure 6-17).
Figure 6-17 WLANs > Edit Page
Step 3
Make sure that 802.1X or WPA1+WPA2 is selected for Layer 2 Security.
Step 4 Check the Web Policy check box under Layer 3 Security.
Step 5 Choose Conditional Web Redirect to enable this feature. The default value is disabled (unchecked
box).
Step 6 If the user is to be redirected to a site external to the controller, choose the ACL that was configured on
your RADIUS server from the Preauthentication ACL drop-down list.
Step 7 Click Apply to commit your changes.
Step 8 Click Save Configuration to save your changes.
Using the CLI to Configure Conditional Web Redirect
Follow these steps to configure conditional web redirect using the controller CLI.
Step 1 To enable or disable conditional web redirect, enter this command:
config wlan security cond-web-redir {enable | disable} wlan_id
Step 2 To save your settings, enter this command:
save config

Cisco SD2008T-NA Specifications

General

Brand	Cisco
Model	SD2008T-NA
Category	Extender
Language	English