6-31
Cisco Wireless LAN Controller Configuration Guide
OL-1926-06OL-9141-03
Chapter 6 Configuring WLANsWireless Device Access
Configuring WLANs
2. The WLANs > New page, which appears when you click New on the WLANs page to create a
WLAN. Figure 6-14 shows the fields in which to enter the profile name and SSID for the WLAN.
Figure 6-14 WLANs > New Page
3.
The WLANs > Edit page, which appears when you click Apply on the WLANs > New page or when
you edit an existing WLAN. Figure 6-15 shows the ID, profile name, and SSID of the WLAN.
Figure 6-15 WLANs > Edit Page
Addition to the Controller CLI
In release 4.0.206.0, the command for creating a WLAN has expanded to allow the addition of the profile
name in the command.
Note The config wlan enable wlan_id and config wlan delete wlan_id commands do not require the profile
name to be specified. Their format has not changed.
The new command for creating a WLAN is as follows.
config wlan create wlan_id profile_name ssid
Note If you do not specify an ssid, the profile_name parameter is used for both the profile name and
the SSID.
Note For releases earlier than 4.0.206.0, the CLI command for creating a WLAN remains as config
wlan create wlan_id ssid.
To Next Page
Loading...
Need help?
General
