10-24
Cisco Wireless LAN Controller Configuration Guide
OL-1926-06OL-9141-03
Chapter 10 Configuring Radio Resource ManagementWireless Device Access
Overriding Dynamic RRM
Statically Assigning Channel and Transmit Power Settings to Access Point
Radios
This section provides instructions for statically assigning channel and power settings using the GUI or
CLI.
Note Cisco recommends that you assign different nonoverlapping channels to access points that are within
close proximity to each other. The nonoverlapping channels in the U.S. are 36, 40, 44, 48, 52, 56, 60,
64, 149, 153, 157, and 161 in an 802.11a network and 1, 6, and 11 in an 802.11b/g network.
Note Cisco recommends that you do not assign all access points that are within close proximity to each other
to the maximum power level.
Using the GUI to Statically Assign Channel and Transmit Power Settings
Follow these steps to statically assign channel and/or power settings on a per access point radio basis
using the GUI.
Step 1 Click Wireless to access the All APs page (see Figure 10-2).
Step 2 Under Access Points, click either 802.11a Radios or 802.11b/g Radios to access the 802.11a (or
802.11b/g) Radios page (see Figure 10-8).
Figure 10-8 802.11a Radios Page
This page shows all the 802.11a or 802.11b/g access point radios that are joined to the controller and
their current settings.
To Next Page
Loading...
Need help?
General
