99
(4)Brushes
(a)Make replacement of brushes that have
been worn down to,or beyond, the wear
limit line.
(b)To remove the brushes from the brush
holder for replacement, unsolder the
leads from the brushes. This will
permit removal of the brushes and
springs.
(c)To install the new brushes, put them in
position in the brush holder and solder
the leads to the brushes.
3.Glow plug
Test for continuity between the terminal and
body as shown in the illustration.
Item Standard
Resistance 0.55
To Next Page
Loading...
Need help?
General