129
1. Make sure that the snap ring is completely
installed in the groove.
2. Pull the brake lever (3) for making sure that the
brake is functioning properly.
3. Aline the hole of the two brake disks on each
side when assembled. (For lubrication purpose)
7-5. REAR AXLE REASSEMBLING
* Reassemble the rear axle with reverse
procedure of disassembling.
(1) REAR AXLE REASSEMBLING
*Reassemble the rear axle with reverse
procedure of disassembling. Use following
values for rear axle reassembling as
adjustment and service standard.
1. Apply lithium grease at lip of oil seal and
install axle shaft carefully not to damage lip.
2. Make sure snap ring is completely installed in
the groove.
3. Adjust the end play of axle shaft to
[0.002~0.008 in.] by liner.
(2) BRAKE ASSY REASSEMBLING
* Reassemble the brake assy with reverse
procedure of disassembling. Use following
values for rear axle reassembling as
adjustment and service standard.
To Next Page
Loading...
Need help?
General