141
9. STEERING
9-1. OPERATOR CONTROL AREA REMOVAL
(1) STEERING WHEEL REMOVAL
1) Remove fixing screws of rear cover and
remove rear cover.
2) Remove fixing bolts (4) and nuts (5) of plate
(3).
3) Disconnect the wire of engine control lever
and shuttle lever.
4) Remove fixing bolts of bracket and remove
bracket and levers.
5) Remove lock nut (18),column fixing bolts
(17) , disk spring (18) (Bothsides) and
column (2) .
6) Remove spring (16), lock nut (15) , tilt lever
fixing bolt (14) and tilt lever (13).
7) Remove hose L (11), R (12), P and return
hose from steering unit.
(1)STEERING UNIT
(2)COLUMN
(3)PLATE
(4)BOLT
(5)NUT
(6)BOOT
(7)SHAFT
(8)STEERING WHEEL
(9)CENTER PAD
(10)NUT
(11)HOSE L (RED TAPE)
(12)HOSE R
(13)TILT LEVER
(14)BOLT
(15)NUT
(16)SPRING
(17)BOLT
(18)DISK SPRING
(19)NUT
(20)LINER
(21)BOLT
To Next Page
Loading...
Need help?
General