54
(3)Put the piston in position on the connecting
rod, making sure the model identification on
the rod is on the same side as the arrow head
on the top of the piston.
(4)Insert the push rod of the Tool into the bore in
the piston for the piston pin and press the pin
with the press.
4.Side seal installation
(1)Coat the side seals with Three Bond 1212.
(2)Insert the side seals between the cylinder
block and the front and rear caps and push
in them by hand as far as possible, with
their rounded side toward the outside of
the cylinder block.
(3)Using a flat plate, push the seals into
position, taking care not to bend them.
5.Piston assembling to connecting rod
(1)Set Piston Setting Tool(31A91-00100)
(special tool)in a hydraulic press.
(2)Put the connecting rod on the tool and
lubricate the bore in the rod for the piston
pin with engine oil.
Observe the indicator of the press when
pressing the piston pin. If the force of the press
is ready to exceed 110 lbf (50 kgf) [490 N], stop
pressing the pin and check the bores in the
piston and connecting rod for alignment.
To Next Page
Loading...
Need help?
General